How To Set up and Balance The Pro hand-held Camera Stabilizer

The first part: Handheld Camera stabilizer adjustment,he basic principle: usually due to people walking will lead to the occurrence of hand-held objects around and around, up and down in three directions together the bumpy movement. Then, the hand-held stabilizer itself can solve the front and rear and left and right direction of shaking

  Playing Camera stabilizer for so long, I also put some experience summed up and share with you, there are some deficiencies in the tutorial. ~

  The first part: Handheld Camera stabilizer adjustment

  1.the basic principle: usually due to people walking will lead to the occurrence of hand-held objects around and around, up and down in three directions together the bumpy movement. Then, the hand-held stabilizer itself can solve the front and rear and left and right direction of shaking, here to explain that the hand-held Camera stabilizer does not "shock", it is to help you in the fulcrum position relative movement so as to maintain the two directions do not occur Swaying. So when you hold it trot, you will find that your arms and pace have helped you to cushion the shock, so the up and down motion damping effect is good or not, directly related to the operator's ability to operate. Of course, if you have a shock arm, double damping due to the two springs will be more effective, here, I mainly explain the use of handheld Camera stabilizer.

  Sevenoak Professional  Camera Stabilizer SK-SW Pro 2
 
  Maximum Length: Approx. 72.5cm
  Minimum Length: Approx. 45cm
  Product weight: Approx. 2.0 kg
  Max load capacity: 3 kg
Sevenoak camera stabilizer

  2.adjusting steps:

  (1) Check: Adjust all the joint buckles to the same straight line, which is beneficial to the balance adjustment of the stabilizer and reduce unnecessary interference factors.

  (2) Installed: find the camera or SLR (the following are the camera instead of) the center of gravity position, usually in the center position, and then center the center of the fast plate alignment camera, and then move the screw to the camera screw hole position Tight.

  (3) loaded weight: First, we have to estimate the weight of the machine, first weight almost weight loaded up, not enough or too much to do the increase or decrease. Then the universal balance section to move the camera direction, the purpose is to minimize the amount of weight, so that the entire equipment more portable. Then put the main lever level, if the weight side quickly pendulum, indicating too much weight, need to reduce the weight, otherwise increase the weight. Let the weight side free to pendulum, 2 to 3 seconds placed in the vertical line of the subject. Here, I would like to remind everyone that we should try our best to make the main pole shorter, and do not lengthen it unless absolutely necessary because there are two problems involved here: First, too long and too long a force Or the wind can make the stabilizer lose its balance;

  Second, each time you have to re-adjust the machine, very troublesome. Well, the balance of the weight at both ends of the main body after we determine, and then determine how the distribution of weight before and after and about two places, we must first about the weight distribution, in general, do not need to add both sides, you will only see To the camera to the left or right side of the deviation from the vertical line is greater than 20 °, then left or right side to add, until it is less than 20 ° position, add the law is "to the camera side opposite ". Before and after the addition of the weight of the law is the same, do not go into details here! Tips, do not take to adjust the weight balance to add weight.

      More information about sevenoak camera rig ,camera slider

Get in Touch With the Latest From Sevenoak
Sevenoak
Sevenoak
Sevenoak
Sevenoak
Sevenoak
Sevenoak
Sevenoak